Here's a new Head Gasket Set & Sump Gasket Set (ENGINE GASKET SET) for the following models from Ford -

FORD

Ford Cortina Mk1 1200

(113e & 114e) (1198cc) (1962-68) (Pre X-Flow)

Ford Cortina Mk1 1500

(118e & 119e) (1498cc)  (1963- Aug 66)

Ford Cortina Mk1 1500GT

(118e & 119e) (1498cc) (1963-Aug 66)

(Manifold Gasket is different on the GT, rest of it is correct)

Here's a new Air Filter (x1) for the following models from Ford -

FORD

Ford Cortina Mk1 (1200cc & 1500cc)       (1962- 66)

(**Not for the 1500GT model**)

(**Not for any Lotus Cortina model *)

(You require x1 Air Filter per car).

Here's a new Water Pump With Gasket & Fan Belt for the following models with a (Pre X-Flow) from Ford -

FORD

Ford Cortina Mk1  (1200, 1500 & GT)    (1962- 66)

(** Excluding Lotus Cortina Mk1 **)

(Dynamo Models Only)

Here's a new Front Wheel Bearing Kit (x1) for the following models with Front Drum Brakes from Ford -

FORD

Ford Cortina Mk1     (1962- Oct 64)

(1200cc, 1500cc Only) 

(** Only for Front Drum Brake models **)

(** Not for Front Disc Brakes models **)

Here's a new pair of Rear Axle Inner Oil Seals (x2) for the following models from Ford -

FORD

Ford Cortina Mk1  (1962-  66)

(1200, 1500, 1500GT & Lotus)

These oil seals are fitted behind the wheel bearings - So you have to take out the wheel bearings to change them.

Here's a new Rear Wheel Bearing Kit (With Fitting Collar) for the following models from Ford -

FORD

Ford Cortina Mk1   (1.2, 1.5, 1.5GT & Lotus 1600cc)      (1962- 66)

(** Not for the Later Cortina Mk2 of 1966- 70 **)

If you have a Kit Car / Modified Car or are unsure then get your old bearing out to compare....

This bearing has no Rubber O Ring round the outside edge (The later Cortina Mk2 bearing does).

This bearing sticks out either side where the central shaft goes in. (The later Cortina Mk2 bearing sticks out only a little bit on one side)