Here's a new Front Wheel Bearing Kit (x1) for the following models from Hillman -

HILLMAN

Hillman Super Minx (Ser 1-4)   (1961- 67) 

The Oil Seal is not included.

Here's a new pair of Universal Joints (x2) for the following models from Hillman -

HILLMAN

Hillman Super Minx                      (1961- 67)

These come complete with all the required circlips so it's an easy fitting job -

Symptoms of worn joints are - A 'clonk' noise under power / pulling away OR continued clonking if the joints have deteriorated badly.

Here's the exact measurements of the joints -

Cup diameter 2.382cm, Joint Diameter 6.130cm

Here’s a new Oil Filter for the following models from Hillman -

HILLMAN

Hillman Super Minx (Mk2 Late) (1592cc)      (1963- 65)

Hillman Super Minx (Mk3)         (1725cc)      (1965- 67)

(** This is the Spin-On Type filter**)

(**Not for earlier Super Minx's of 1961- 63 which used a Paper type Oil Filter**) 

(** If you have the earlier Paper type filter fitted then Don't Buy This - It Won't Fit & it Won't Convert to a Spin on filter **)

Here’s a new Oil Filter for the following 4 Cylinder models from Hillman -

HILLMAN

Hillman Minx Ser. 1     (1390ccc)  (1956- 57)

Hillman Minx Ser. 2     (1390ccc)  (1957- 58)

Hillman Minx Ser. 3     (1500cc)   (1958- 59)

Hillman Minx Ser. 3a   (1500cc)   (1959- 60)

Hillman Minx Ser. 3b   (1500cc)   (1960- 61)

Hillman Minx Ser. 3c   (1600cc)   (1961- 63 Only)

(** Not for the later Ser.5/6/7 Minx's of 1963-67 which used a spin on Oil Filter **)