Here's some Bonnet Seals suitable for the following models from Morris -

MORRIS

Morris Minor & Traveller (1948- 71) 

The length supplied is enough for one Minor (Both sides) with a small bit extra, you just cut it to the exact requirements.

The photo shows the end profile of this seal so you can see how it goes.

These are new and unused seals, they are recently manufactured and are of excellent quality as you can see from my feedback.

These fit on the body one each side, here's enough for one car.

Here's a new Head Gasket Set (Made in UK) for the following models from Morris -

MORRIS

Morris Minor  (1952- 71)

(803cc, 948cc & 1098cc)
 

(That's all Minors except the earlier Side Valve 918cc engined Minor of 1948- 52).

Here's a new Clutch Fork Arm Gaiter for the following models from Morris -

MORRIS

Morris Minor  (**From 1952- 71**)

(Suits 803cc, 948cc & 1098cc)

Here's a new Timing Chain Kit for the following models from Morris -

MORRIS

Morris Minor    (803cc, 948cc & 1098cc)        (1952- 71)

(** Not for the earlier Side Valve Minor of 1948- 52 **)

Included in this kit it the following -

Timing Chain 

Felt Oil Seal for Early Timing Cover

Rubber Oil Seal for Late Timing Cover

Tensioner Rings x2

Crankshaft Lock Tab

You need this kit for any engine rebuild, the oil seal will have gone hard and the timing chain will have stretched making it noisey and more likely to break.

Here's a new set of Front Brake Shoes for the following models from Morris-

MORRIS

Morris Minor 1098cc  (**From Oct 62- 71**)

(**These are for 8" diameter drums fitted on the 1098cc model**)

(**Not for earlier models made before Oct 62 which used 7" drums**)

Here's a new pair of Front Engine Mounts (x2) for the following models from Morris -

MORRIS

Morris Minor    (1952- 71)

(803cc, 948cc, 1098cc)

(Includes Van & Pickup)

Minors before 1952 used the gearbox mounts as engine mounts - see the picture if unsure.

Here’s a new Ignition Tune Up Kit for the following models from Morris -

MORRIS

Morris Minor 1000 (1967- 71)

(Note : Only for Minors after 1967 with a 'Top Entry' cap).

These models have a Lucas 4 Cyl distributor.

This kit includes the following parts -

Distributor Cap

Points

Rotor Arm

Condenser

Here's a new Ignition Coil for the following models from Morris -

MORRIS

Morris Minor       (1948- 67 Only )

It's a Non-Ballast coil for use with Screw-In Leads (Not Push- In Leads).

(** Check if you have  Push In or Screw In Leads **)

*** NOTE - This may be coloured Black or Silver depending on what the supplier sends me ***

This function of this coil is to generate the 000's of volts required by your spark plugs, they deteriorate with age and the insulation between the wires inside can breakdown and therefore the coil needs replacing once in a while.

Here's a new pair of Front Engine Mounts (x2) & Gearbox Mounts (x2) for the following models from Morris -

MORRIS

Morris Minor    (From 1952- 71)

(803cc, 948cc, 1098cc)

(Includes Van & Pickup)

Before 1952 the Side Valve model used the different Engine Mounts.

Here's a new Boot Rubber Seal for all the following models from Morris -

MORRIS

Morris Minor Saloon (1948- 71)

(Not for the Rear Doors on the Traveller / Estate / Van).

The length supplied is enough for one Minor with a small bit extra, you just cut it to the exact requirements.

Some early Minors used a Glue on Boot Seal - It's Rubbish. This press on seal will replace it.

The photo shows the end profile of this seal so you can see how it goes, easy to fit - just press on.