Home :: Classic Car Parts :: Triumph Car Parts :: Triumph Herald & Vitesse Parts :: BODY PARTS- MIRRORS, BADGES ETC Triumph Herald & Vitesse :: TEX BULLET DOOR MIRROR x1 (Triumph Herald & Vitesse) (1959- 71)

TEX BULLET DOOR MIRROR x1 (Triumph Herald & Vitesse) (1959- 71)

TEX BULLET DOOR MIRROR x1 (Triumph Herald & Vitesse) (1959- 71)
18.00
18.00 inc vat

Here's a single new Bullet Door Mirror made by TEX.

 

(Original supplier to most UK motor manufacturers).

 

This is Stainless Steel and the highest quality.

 

This will fit on either side and can be used on almost any car but will particularly suit the following older ones where the square TEX mirrors look a bit to modern -

 

Well suited for -

 

Triumph Herald

Triumph Vitesse

 

 

This comes complete with the fitting kit, a gasket and two screws -

 

You will need to drill holes in your door panel to fit this (5cm apart - from the centres of the holes) and insert the screws through the door panel from the inside.

 

The glass is flat (Not Convex) with an 88mm diameter, the base is 9.1cm long.

 

Quantity Out of stock
FRONT & REAR BRAKE HOSES x3 (Sunbeam Talbot 80)
DISTRIBUTOR CAP POINTS ROTOR ARM CONDENSER (Triumph 1500 RWD Saloon) (From Dec 1974- 75)
CLUTCH SLAVE CYLINDER REPAIR SEALS KIT (Ford Cortina Mk2) (1966- 70)
FRONT & REAR BRAKE HOSES x3 (Sunbeam Talbot 80) DISTRIBUTOR CAP POINTS ROTOR ARM CONDENSER (Triumph 1500 RWD Saloon) (From Dec 1974- 75) CLUTCH SLAVE CYLINDER REPAIR SEALS KIT (Ford Cortina Mk2) (1966- 70)
31.00
10.00
4.50
 
CLUTCH SLAVE CYLINDER (Rover P6 2000 & 2200) (1963- 77)
CORE PLUG ENGINE SET (Morris Oxford) (Ser. 2, 3, 4, 5, 6) (1954-71)
SUMP GASKET ENGINE SET (MG Magnette Mk4) (** From 1966- 68 **)
CLUTCH SLAVE CYLINDER (Rover P6 2000 & 2200) (1963- 77) CORE PLUG ENGINE SET (Morris Oxford) (Ser. 2, 3, 4, 5, 6) (1954-71) SUMP GASKET ENGINE SET (MG Magnette Mk4) (** From 1966- 68 **)
16.00
3.75
14.95
 
(FRONT or REAR) BRAKE CALIPER BLEED NIPPLES x2 (Jaguar MkX) (3.8 & 4.2) (1961- 70)
SPEEDO CABLE (Lotus Elan) (S1,S2,S3,S4, SPrint & Plus 2) (1962- 74)
REAR BRAKE PAD FITTING KIT - PINS (Jaguar 420) (1966- 68)
(FRONT or REAR) BRAKE CALIPER BLEED NIPPLES x2 (Jaguar MkX) (3.8 & 4.2) (1961- 70) SPEEDO CABLE (Lotus Elan) (S1,S2,S3,S4, SPrint & Plus 2) (1962- 74) REAR BRAKE PAD FITTING KIT - PINS (Jaguar 420) (1966- 68)
10.50
12.00
7.50