STARTER RING GEAR (Triumph TR5 & TR6)

STARTER RING GEAR (Triumph TR5 & TR6)
21.00
21.00 inc vat

Here's a new Starter Ring Gear, for the following models from Triumph -

 

 

TRIUMPH


Triumph TR5

Triumph TR6

 

 

This fits round your engine flywheel and the starter motor engages it's teeth to turn your engine.

 

With time the teeth become worn away and your starter motor will jam so that you have to rock the car back and forward in gear to free it off - then try again.

 

After more wear the starter motor will just skip over the teeth of the ring gear making a noise.

 

If either of these happen you need to buy this ring gear.

 

To fit this you have to take out the gearbox, remove your old ring gear by hacksawing it off.

 

You then have to heat up this new ring gear with a gas torch so that it expands. You then place it over your flywheel and it will cool and shrink to fit.

 

Quantity
CLUTCH KIT (MG TB TC TD) (1939- 51)
CLUTCH MASTER CYLINDER REPAIR SEALS KIT (Reliant Scimitar) (SE4 Late & SE5) (Feb 1969-73)
REAR BRAKE SHOES SET (TVR Grantura Mk3, Griffiths 200) (** From 1962- 66 **)
CLUTCH KIT (MG TB TC TD) (1939- 51) CLUTCH MASTER CYLINDER REPAIR SEALS KIT (Reliant Scimitar) (SE4 Late & SE5) (Feb 1969-73) REAR BRAKE SHOES SET (TVR Grantura Mk3, Griffiths 200) (** From 1962- 66 **)
125.00
7.50
17.50
 
STARTER RING GEAR (Austin Healey Frogeye Sprite) (948cc) (1958- 61)
OIL PRESSURE SWITCH (Ford 100e, Popular & Thames) (1959 - 65)
INLET MANIFOLD GASKET (Triumph 2000 Mk2 & 2500 Mk2) (** From Oct 68- 77 **)
STARTER RING GEAR (Austin Healey Frogeye Sprite) (948cc) (1958- 61) OIL PRESSURE SWITCH (Ford 100e, Popular & Thames) (1959 - 65) INLET MANIFOLD GASKET (Triumph 2000 Mk2 & 2500 Mk2) (** From Oct 68- 77 **)
18.50
4.25
3.95
 
FRONT WHEEL HUB BEARING KIT x1 (Triumph Stag) (1970- 77)
FRONT TIMING COVER ENGINE OIL SEAL (Triumph TR5 & TR6) (1967- 76)
CLUTCH RELEASE THRUST BEARING (Riley 1.5 Saloon) (1958- 65)
FRONT WHEEL HUB BEARING KIT x1 (Triumph Stag) (1970- 77) FRONT TIMING COVER ENGINE OIL SEAL (Triumph TR5 & TR6) (1967- 76) CLUTCH RELEASE THRUST BEARING (Riley 1.5 Saloon) (1958- 65)
10.50
2.75
14.50